HPE Community
BladeSystem - General
1752647 Members
5852 Online
108788 Solutions
New Discussion

Can I Configure Which PSU is used for Primary and Secondary? (C7000)

 
rboelens
Occasional Contributor

‎08-26-2017 12:14 PM - edited ‎08-26-2017 12:16 PM

‎08-26-2017 12:14 PM - edited ‎08-26-2017 12:16 PM

Can I Configure Which PSU is used for Primary and Secondary? (C7000)

I have a C7000 BladeCentre with an A and B Power Feed going to a 208/240v Single Phase Power Module with all 6 PSUs Populated in Redundant Mode (3+3)

It costs me significantly less to use my A feed per Kw/h than to use my B feed due to the A feed being supplimented by the building's Solar, which obviously will be a problem each day when the sun goes down.

So, what I would like to do is, somehow configure the chassis to prioritize drawing power from Line A (PSUs 1, 2 and 3), and when that drops at sundown, switchover to Line B (PSUs 4, 5, 6) during the night.

Is this possible? If so, how can I configure it to do so?

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.