HPE Community
BladeSystem - General
1753717 Members
4340 Online
108799 Solutions
New Discussion

HP SUM for mezzanine cards

 
Craig620
Occasional Contributor

‎10-07-2013 01:08 PM - edited ‎10-07-2013 04:20 PM

‎10-07-2013 01:08 PM - edited ‎10-07-2013 04:20 PM

HP SUM for mezzanine cards

I'm using SUM 5.3.5, and in the HTML report I see Mezz#1, Mezz#2, Mezz#3 in the header.

Further down in the "BLADE SERVERS (Quick Glance)" section I see values for the type of mezzanine card, when installed

Where is it hiding the firmware VERSION of the mezzanine card?

Thanks

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.