cancel
Showing results for 
Search instead for 
Did you mean: 

HPPM configuration w/hpux

Mark Sabin
Occasional Visitor

HPPM configuration w/hpux

I'm running hpux 11i v1. I just installed hppm ver 4.0. (I know there are newer versions) How do I configure it for the shutdown delay? I know that ups_mon uses the ups_conf file but what file does hppm use? Also how do I config it to email me in the evnt of a shutdown. The user manul is of little help. It basically talks about how to config this via windows.
3 REPLIES
Torsten.
Acclaimed Contributor

Re: HPPM configuration w/hpux

Once it is configured and running, I would go to the power manager homepage (you did configure the web port already) and modify the values from there.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Mark Sabin
Occasional Visitor

Re: HPPM configuration w/hpux

Excuse my ignorance but how do I reach the homepage?
Torsten.
Acclaimed Contributor

Re: HPPM configuration w/hpux

While installing hppm it is asking this question:

Please enter a port to use for web communications [80]: 8888


This is the port, point your browser to

http://your_servers_IP:

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!