- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: Hp Gen8 and C3000, question about paths
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-15-2013 08:38 AM
12-15-2013 08:38 AM
Hp Gen8 and C3000, question about paths
I just read the quickspecs of BL420c G8, it says that mezzanine 1 is connected to bays 3&4 and mezzanine 2 is connected to bays 5&6 (or to bays 5,6,7/8 for quad port mezzanines). What does happen when this blade server is used in a c3000? Can I use mezzanine slot2?
Thanks in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-17-2013 01:59 PM
12-17-2013 01:59 PM
Re: Hp Gen8 and C3000, question about paths
You can:
- Mezzanine slot 2 ports 1 and 3 are routed to bay 3
- Mezzanine slot 2 ports 2 and 4 are routed to bay 4
Check out the c3000 Service Manual from this site:
http://h18004.www1.hp.com/products/blades/components/c-class-tech-maintaining.html
...and go the section "Interconnect Bay Numbering".
-Bob
Was this helpful? Like this post by giving me a thumbs up below!