HPE Community
BladeSystem - General
1753524 Members
6905 Online
108795 Solutions
New Discussion

Intelligent Provisioning [F10] Prompt Missing

 
twokilo
Occasional Collector

‎01-27-2016 11:14 AM

‎01-27-2016 11:14 AM

Intelligent Provisioning [F10] Prompt Missing

I had an event with my ProLiant BL460c Gen9 servers that I cannot explain.  Hopefully someone can help explain.

I had a ProLiant BL460c Gen9 that mysteriously had the Intelligent Provisioning [F10] Prompt go missing.

I was attempting to apply a Profile using HP OneView (it was failing); when I noticed that the Intelligent Provisioning [F10] Prompt Missing during the POST.  I attempted to enter the Setup [F9] to enable Intelligent Provisioning; but the setting to ENABLE/DISABLE was missing from the menu list.

I reset the blade (eFuse) and watched the POST and the [F10] Prompt  was now showing as "DISABLED".  I entered the Setup [F9] and was able to re-enable Intelligent Provisioning and everything is working now.

I setup the server initially several months ago.  The Intelligent Provisioning [F10] Prompt was there and enabled because I used it to set the blade and apply the profile the first time. 

Can anyone explain, why it "disappeared"?

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.