PGP for HP-UX 10.20

[Robin King_1]

I have a horrible old 10.20 system still lurking around, and I need to get PGP working on it. I've installed it on 11i without any problem, but needless to say I can't find any packages for 10.20.

Does anyone know where I can source a copy for commercial use?

[Fabio Ettore]

Hi Robin,

http://www.pgpi.org/cgi/download.cgi?filename=PGPcmdln_6.5.8.HPUX_FW.tar.gz

I found a good version for HP-UX 10.20 and below you can see system requirements for unix (there is HP-UX 10.20 or later).

************************************
SYSTEM REQUIREMENTS

To install PGP Command Line on a Windows NT or Windows 2000 system, you must have:

Windows NT version 4.0 (Service Pack 3 or later)
or
Windows 2000 (RC2 or later)
32MB RAM minimum
6MB disk space for software
To install PGP Command Line on a UNIX system, you must have:
One of these flavors of UNIX:
Sun Solaris for SPARC version 2.51 or later
AIX 4.2 or later
HPUX 10.20 or later
Linux x86 Red Hat (RPM) 5.0 or later
32MB RAM minimum for Linux, AIX, and HPUX
9MB disk space for software
9MB disk space in /opt directory for Solaris
************************************

I got it from http://www.pgpi.org.

Hope this helps you.

Best regards,
Fabio

[Robin King_1]

Thanks very much, that's exactly what I needed.

(I was assigning you 10 points, and the slider went to 7 before I realised, sorry)