General
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant ML350 G3 and Red Hat Enterprise AS 2.1

SOLVED
Go to solution
marco_84
Occasional Advisor

Proliant ML350 G3 and Red Hat Enterprise AS 2.1

I can't install the Red Hat AS 2.1 on the Proliant ML 350 G3, it give the following message "An error has ocurred - no valid device were found on wich to create new filesystem. Please check your hardware for the cause of this problem."
i think the HP smart array 641 controller needs a driver, then i got the disk driver cpq_cciss-2.4.48-3.rh21.i386.dd from the web page h18004.www1.hp.com/support/files/storage/us/download/19863.html but the proliant give me the same error

Thanks in advanced
3 REPLIES
Bill Wood_3
Respected Contributor
Solution

Re: Proliant ML350 G3 and Red Hat Enterprise AS 2.1

The DUD you are using only supports QU2 RHAS 2.1 media. Please use the previous version of the DUD located at the following url if you are using the original RHAS2.1 media:

http://h18023.www1.hp.com/support/files/server/us/download/17784.html

After you are finished installing, you can upgrade the kernel to the latest supported errata (e.27 currently) and use the cciss driver rpm to install 2.4.48. The rpm is located at the following:

http://h18023.www1.hp.com/support/files/server/us/download/18859.html

NOTE: Before you install the cciss driver rpm, make sure you edit modules.conf and remove the second cciss entry.
marco_84
Occasional Advisor

Re: Proliant ML350 G3 and Red Hat Enterprise AS 2.1

Thanks Bill

The Proliant was installed with Red Hat AS 2.1


Thanks again and you won 10 points
naimkw
Occasional Visitor

Re: Proliant ML350 G3 and Red Hat Enterprise AS 2.1

Hi i m also getting the same error while installin RH2.1 AS .When i select manually partition wiht diskdruid and click next ,it give me this error.
An error has ocurred - no valid device were found on wich to create new filesystem. Please check your hardware for the cause of this problem."