- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Servers - General
- >
- Re: UPS Management modules?
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-02-2013 11:41 AM - last edited on 07-04-2013 07:21 PM by JinJing1
07-02-2013 11:41 AM - last edited on 07-04-2013 07:21 PM by JinJing1
UPS Management modules?
Sorry if this is the wrong forum.
Looking for help configuring out AF401A management modules for our UPS. I can't seem to connect to the module through the configuration port.
Connected config port to computer via usb-serial converter.
Using 115200 bits
8 data bit
parity none
stop bits 1
flow control none
Using Putty to connect. Push reset button. Seems to connect but we never see a post to continue with configuration.
Any help would be appreciated.
P.S. This thread has been moved from ProCurve-ProVision-Based to Servers > general. -HP Forum Moderator
- Tags:
- UPS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-05-2013 08:50 PM
08-05-2013 08:50 PM
Re: UPS Management modules?
Hi,
Following are the stesp required to enter HP UPS Management Module Service Menu
- Connect a network cable in the "Config-PassThru" port on the UPS Management Module, and the other end to a server or laptop, with a RJ45 to DB9 serial converter.(Check the steps for connecting configuration cable on Page 21 of the user guide @ http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c00865951/c00865951.pdf
- Run HyperTerminal or any other console emulation software (like PuTTY).
- Press the RESET button on the UPS Management Module.
- On the session screen, the POST executes, and then a prompt appears. Press any key within 5 seconds to enter the HP UPS Management Module Service Menu.