Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
cancel
Showing results for 
Search instead for 
Did you mean: 

Upgrade help

Thomas Luong
Occasional Contributor

Upgrade help

I will be upgrading from a K260 to a K360. The upgrade will eliminate HPPB slot 10/4/12, which is currently in use by our controller on the K260.

What are the steps to re-map the address and not lose any of the volume groups?

Note: Running HP-UX 10.20

The controller affected is 1 of 2 attached to an AutoRaid.
2 REPLIES
Andy Monks
Honored Contributor

Re: Upgrade help

with the upgrade comes a script that converts the I/O mappings.

procupgrade.k260 (or something like that). it's on a tape/cd thats part of the h/w kit.
Patrick Wessel
Honored Contributor

Re: Upgrade help

Are you sure that you are loosing HP-PB bus slots on an upgrade from K260 to K360? I don't think so...
If you lose a SCSI host bus adapter with a none boot disk you can export the VGs on this disks (or disk arrays) and import them after the upgrade. This is the easiest way
There is no good troubleshooting with bad data