General

Re: change settings to HP Laserjet 1320

 
Ilda
New Member

change settings to HP Laserjet 1320

I recently bought an HP Laserjet 1320. We use a Linux program and I do not know how to change the setting to where it prints right. Right now it only prints 1/4 of a page and the rest of it is blank, also the font is very big and the whole report is not printed due to the font size. I was told that I needed to change the settings to PLC 6 but I do not know how to do it if the printer is not connected to a Windows computer, it is connected to a computer that is run by the Linux program. I really need to know how to change the setting. Please reply A.S.A.P
1 REPLY 1
xyko_1
Esteemed Contributor

Re: change settings to HP Laserjet 1320

Hi Ilda,

first off all you have to check the linux printing system and the configuration to the printer. On the following link will have some instructions on how to configure that printer on Linux.

http://linuxprinting.org/show_printer.cgi?recnum=HP-LaserJet_1320

Hope it helps,
xyko