Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
General
cancel
Showing results for 
Search instead for 
Did you mean: 

change settings to HP Laserjet 1320

Ilda
Occasional Visitor

change settings to HP Laserjet 1320

I recently bought an HP Laserjet 1320. We use a Linux program and I do not know how to change the setting to where it prints right. Right now it only prints 1/4 of a page and the rest of it is blank, also the font is very big and the whole report is not printed due to the font size. I was told that I needed to change the settings to PLC 6 but I do not know how to do it if the printer is not connected to a Windows computer, it is connected to a computer that is run by the Linux program. I really need to know how to change the setting. Please reply A.S.A.P
1 REPLY
xyko_1
Esteemed Contributor

Re: change settings to HP Laserjet 1320

Hi Ilda,

first off all you have to check the linux printing system and the configuration to the printer. On the following link will have some instructions on how to configure that printer on Linux.

http://linuxprinting.org/show_printer.cgi?recnum=HP-LaserJet_1320

Hope it helps,
xyko