- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - Linux
- >
- does qlogic driver 7 on RHEL3 U2 i386 support MSA1...
Operating System - Linux
1753774
Members
7185
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2004 04:11 AM
12-27-2004 04:11 AM
does qlogic driver 7 on RHEL3 U2 i386 support MSA1000 F200?
Hi,
I have a customer running rhel3 u2 i386 on Proliant systems. They're tring to connect two systems(each with two FCA2214) to MSA1000 dual controller + dual B series SAN switches with qla2300 v7.01.01. I think is is a HP supported config(from qla2300 release notes), but the customer can't failover luns.
They see 'FAIL OVER FROM ... To ...' in dmesg but just lost the LUNs. Sb. said SSP should be enabled for Linux failover, I don't know where does this comment come from, but will try tomorrow. But anybody can confirm this configuration is supported?
Thanks a lot!
Tommy
I have a customer running rhel3 u2 i386 on Proliant systems. They're tring to connect two systems(each with two FCA2214) to MSA1000 dual controller + dual B series SAN switches with qla2300 v7.01.01. I think is is a HP supported config(from qla2300 release notes), but the customer can't failover luns.
They see 'FAIL OVER FROM ... To ...' in dmesg but just lost the LUNs. Sb. said SSP should be enabled for Linux failover, I don't know where does this comment come from, but will try tomorrow. But anybody can confirm this configuration is supported?
Thanks a lot!
Tommy
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP