installing oracle 10g standard edition on HP-UX 11i MCSG cluster

[d.yoman]

I will be installing Oracle 10G standard edition on HP-UX 11i MCSG 11.16 cluster. I will be using RAW file systems.I have already installed the GOLD PACK of June 2005 patches. Can somebody send me a step by step document for the same related to cluster configuration and oracle on cluster.

[Yogeeraj_1 · Accepted solution]

hi,

above all thing, run the validate script (downloadable from metalink) to see if you environment has been properly configured for the installation.

then refer to the detailed metalink note:182177.1 - Step-By-Step Installation of RAC on HP-UX, which describes the following:
1. Configuring the Cluster Hardware
o 1.1 Minimal Hardware list / System Requirements
+ 1.1.1 Hardware
+ 1.1.2 Software
+ 1.1.3 Patches
o 1.2 Installing Disk Arrays
o 1.3 Installing Cluster Interconnect and Public Network Hardware
o 1.4 Unix User and Group Creation
2. Creating a Cluster
o 2.1 Modifying the /etc/lvmrc file
o 2.2 Create a Shared Logical Volume
o 2.3 Cluster Software Installation
o 2.4 Form a One-Node Cluster
o 2.5 Basic Cluster Administration
o 2.6 Log Files for the Cluster
3. Preparing for the Installation of RAC
o 3.1 Configure the Shared Disks
o 3.2 UNIX Pre-Installation Tasks
o 3.3 Using the Oracle Universal Installer for Real Application Clusters
o 3.4 Create a RAC Database using the Oracle Database Configuration Assistant
4. Administering Real Application Clusters Instances
5. References

hope this helps!

kind regards
yogeeraj

[d.yoman]

Hi Yogeeraj,
Thanks for the reply. It it not going to be RAC cluster. It is going to be Active/Standby cluster. For RAC cluster a lot of documents are available but i could not find documents for 10G with SG without RAC. I will be thankful if you can provide one. Also i dont have access to metalink.

[Ranjith_5]

Hi yoman,

Hi See this thread.

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=908229

Regards,
Syam