itanium Processors

[Christian_101]

you cant tell me if the HP-UX v2 is only for Itanium Processors ?




Thaks Regards.......

[Steven E. Protter]

Shalom,

HP-UX 11i version 2(11.23) and the upcoming HP-UX 11i version 3(11.31) run on both Itanium and PA-RISC processors.

SEP

[Biswajit Tripathy]

The initial version of HP-UX 11i, v2 release
(which was released sometimes in 2003)
supported ONLY itanium (no PA-RISC support).
Later, in Sept 2004, another version of 11i v2 was
released that had the support for Itanium and
PA-RISC.

If you are not sure what version you have, run
the following command:

# swlist | grep HPUXBaseAux

Above command on my Sept 2004 HP-UX 11i,
v2 gives the following output:

HPUXBaseAux B.11.23.0409 HP-UX Base OS Auxiliary

Note B.11.23.0409 (specifying Sept 2004 release).
This means, I have the Sept 2004 release that
supports both itanium and PA-RISC. If you have
a later version, then that is fine too. But if
prints only "B.11.23", then it's a copy of initial
2003 release and supports only Itanium.

Hope this is clear.

- Biswajit

[Geoff Wild]

As others have said, it runs on both:

http://h18000.www1.hp.com/products/servers/byos/hpuxservers.html

Rgds...Geoff