Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
cancel
Showing results for 
Search instead for 
Did you mean: 

pat_set_hardfail_enable

Paul Sperry
Honored Contributor

pat_set_hardfail_enable

Anyone have an idea what is causing the pat_psm error below which is in the syslog.log.
It's is a L1000, 11.11, 64Bit
(yes I have a server called moron)

Jan 2 14:25:06 moron inetd[536]: Configuration complete
Jan 2 14:28:10 moron pwgrd: Started at Thu Jan 2 14:28:10 2003, pid = 944
Jan 2 14:28:10 moron vmunix:
Jan 2 14:28:10 moron vmunix: Line 4921 in /ux/core/kern/common/io/pat_psm.c: pat_set_hardfail_enable - status -13
Jan 2 14:28:15 moron diagmond[999]: started
Jan 2 14:28:16 moron /usr/sbin/envd[1002]: restart, and read the configuration file
Jan 2 14:28:11 moron vmunix:
Jan 2 14:28:22 moron above message repeats 7 times
Jan 2 16:28:22 moron krsd[1089]: Delay time is 300 seconds
Jan 2 14:28:11 moron vmunix: Line 4921 in /ux/core/kern/common/io/pat_psm.c: pat_set_hardfail_enable - status -13
Jan 2 14:29:11 moron above message repeats 7 times
Jan 2 14:29:10 moron vmunix:
Jan 2 14:29:10 moron vmunix: Line 4921 in /ux/core/kern/common/io/pat_psm.c: pat_set_hardfail_enable - status -13
Jan 2 14:35:05 moron vmunix: Line 4921 in /ux/core/kern/common/io/pat_psm.c: pat_set_hardfail_enable - status -13
Jan 2 14:44:56 moron above message repeats 63 times
2 REPLIES
erics_1
Honored Contributor

Re: pat_set_hardfail_enable

Paul,

You need to install firmware patch PHSS_25105 which should take care of these messages.

Best Regards,
Eric
Paul Sperry
Honored Contributor

Re: pat_set_hardfail_enable

sorry for not getting back to this.
I have PHSS_25685 and was still getting this error. Yesterday I changed out the system board and the errors have gone away so far :)

Warning: 02/01/24 - This Non-Critical Warning has been issued by HP.

- PHSS_25105 fails to update the system firmware correctly
when installed. The /usr/conf/L1000srvrflash utility
provided in the patch is corrupt, which results in the
following error during the system reboot when the patch
is installed:

ISL booting hpux srvrflash
Boot
: disk(0/0/1/1.2.0.0.0.0.0;0)srvrflash
Exec failed: Exec format error

- The behavior is corrected in PHSS_25685, which is released.
- Since the behavior does not have a negative effect on the
system, it simply does not update the system firmware,
it is not necessary to remove PHSS_25105 from systems on
which it is installed. HP recommends using PHSS_25685
instead of PHSS_25105 to update the system firmware on
L1000 and L2000 systems.