1745909 Members
4115 Online
108723 Solutions
New Discussion

Re: update-ux error

 
RC Park
Frequent Advisor

Re: update-ux error

Rommel,

Please verify:
1. Your vPar running in 11iV2, was it on an itanium platform, or did you move it to one for purpose of this upgrade?

2. When issuing the commands suggested by others in this thread, were you doing so on the vPar booted in 11iV2 on the disk you've identified?

If your boot disk was from a PA-RISC platform, and now you're running Itanium, you'll have to take steps to prepare the disk as an EFI boot disk. Specific instructions can be provided if necessary. Depending on your setup, you may have to completely rebuild the disk. You didn't mention it, but are you using ignite in any way in this procedure?

-RCP