xp128 luns no see on lunix rh 2.4

[Raul Andrade_1]

Hi,
Im have a hp xp128 storage, luns presented a linux RH 2. When trying discover luns presented the next error.
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi1 : SCSI emulation for USB Mass Storage devices
Starting timer : 0 0
Vendor: Model: Rev: 1.89
Type: Direct-Access ANSI SCSI revision: 02
Starting timer : 0 0
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 256000 512-byte hdwr sectors (131 MB)
sda: Write Protect is off
sda: sda1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
usb.c: USB disconnect on device 00:0f.2-4 address 2
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sense key Not Ready
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 2
I/O error: dev 08:00, sector 4
I/O error: dev 08:00, sector 6
I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 2
I/O error: dev 08:00, sector 4
I/O error: dev 08:00, sector 6
unable to read partition table

[Kodjo Agbenu]

Hi,

In your syslog file, "sda" (or "scsi1") stands for an USB key.

On your XP128, do you have a LUN numbered "0" ? After that LUN0, are subsequent Linux LUNs consecutive ?

I have no XP storage knowledge, however I remember that there is a config parameter to specify the operating system type. Have you selected the right value ?

Good lcuk.
Kodjo