Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
General
cancel
Showing results for 
Search instead for 
Did you mean: 

xp128 luns no see on lunix rh 2.4

Raul Andrade_1
Frequent Advisor

xp128 luns no see on lunix rh 2.4

Hi,
Im have a hp xp128 storage, luns presented a linux RH 2. When trying discover luns presented the next error.
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi1 : SCSI emulation for USB Mass Storage devices
Starting timer : 0 0
Vendor: Model: Rev: 1.89
Type: Direct-Access ANSI SCSI revision: 02
Starting timer : 0 0
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 256000 512-byte hdwr sectors (131 MB)
sda: Write Protect is off
sda: sda1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
usb.c: USB disconnect on device 00:0f.2-4 address 2
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sense key Not Ready
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 2
I/O error: dev 08:00, sector 4
I/O error: dev 08:00, sector 6
I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 2
I/O error: dev 08:00, sector 4
I/O error: dev 08:00, sector 6
unable to read partition table
1 REPLY
Kodjo Agbenu
Honored Contributor

Re: xp128 luns no see on lunix rh 2.4

Hi,

In your syslog file, "sda" (or "scsi1") stands for an USB key.

On your XP128, do you have a LUN numbered "0" ? After that LUN0, are subsequent Linux LUNs consecutive ?

I have no XP storage knowledge, however I remember that there is a config parameter to specify the operating system type. Have you selected the right value ?

Good lcuk.
Kodjo
Learn and explain...