HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Console Connection...Plug & Play??

H_16
Trusted Contributor

Console Connection...Plug & Play??


I have an N-Class PA-RISC server running 11.23

I need to connect a console to this server while it's running. Will this cause problems with the server. Will I have to reboot for the server to recognize the console??
3 REPLIES
Pete Randall
Outstanding Contributor

Re: Console Connection...Plug & Play??

I have a console that is shared by several servers (rp7410, rx3600, etc) and I commonly unplug it from one to connect it to another. It comes up with no problem. Of course these servers have always had the console. They were first installed using the console, so there may have been some configuring going on then and there, but I'm unaware of any special requirements.

I say go ahead and try it, it should work.


Pete

Pete

Re: Console Connection...Plug & Play??

this should have no effect whatsoever on the server, so just do it
My house is the bank's, my money the wife's, But my opinions belong to me, not HP!
cnb
Honored Contributor

Re: Console Connection...Plug & Play??

Several Console connection options for the N-class are covered in here, starting on page 93:

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01896362/c01896362.pdf




Rgds,