Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

GSP log selection options

SOLVED
Go to solution
derek b smith_1
Regular Advisor

GSP log selection options

I am support some older machines, N4000-44 running GSP A.01.06.

When I go into SL

SL

Select Chassis Code Buffer to be displayed:
Incoming, Activity, Error, Current boot or Last boot? (I/A/E/C/L)

1) Is viewing L sufficient when compared to viewing E?

2) Should I look at just E, just E and L, C and E, etc.? I normally just look at L.

3) For the Alert levels, when 3 or higher I should be notified to look to see what is wrong? Or at level 5 or higher?

thank you!
3 REPLIES
Torsten.
Acclaimed Contributor
Solution

Re: GSP log selection options

Use "e" for error messages.

Usually level 3 and higher is important, level 2 is informational.

BTW, the diagnostics should filter this already and alert you by mail and via syslog.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
derek b smith_1
Regular Advisor

Re: GSP log selection options

yeah I know about DIAG, but will the ATTN light be activated with alert 3 or higher?

Here is an entry at lvl 8, but no date. I assume the entry means a reboot occurred? We reboot weekly.


SYSTEM NAME: XxxxxxX
ALERT LEVEL: 8 = Boot Possible, performance impaired

SOURCE DETAIL: 6 = service processor SOURCE ID: 0
PROBLEM DETAIL: 1 = selftest result

CALLER SUBACTIVITY: 03 = console
REPORTING ENTITY TYPE: 1 = service processor REPORTING ENTITY ID: 00

0x4810028166002030 6E657464 7454656C type 9 = ASCII Message tTelnetd
0x4810028166002030 6167652E 4D657373 type 9 = ASCII Message Message.
g3jza
Esteemed Contributor

Re: GSP log selection options

Hi,

the attention led starts to flash yellow when error level 3 or higher occurs. That's a bit weird, that you don't see any timestamp associated with this event.