Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Terminal manual

Arockia Jegan
Trusted Contributor

HP Terminal manual

From where can I get the manula/documentation for HPUX terminal? I'm having problem with the HP3000 system. The 3rd LED is amber now. It's not allowing me to type. Looks like keyboard is having some issue.
3 REPLIES
Sajid_1
Honored Contributor

Re: HP Terminal manual

hello,

which terminal? do you have any part numbers? Check the documents here:
www.docs.hp.com
learn unix ..
paul courry
Honored Contributor

Re: HP Terminal manual

If you can find the model number of the HP terminal you are using then go to

partsurfer.hp.com

and look up the part number of the manual.
David Bell_1
Honored Contributor

Re: HP Terminal manual

Sounds like someone may have accidently put the system in remote mode.

See if you can do a to gain access to the CM> or GSP> to change the remote access to "off" or type in "co" to return it to console mode.

Also verify there is an * in the "F4" key field which is "Remote Mode".

If this is a 700/9X terminal, power off the terminal, hold down the 'D' key while powering on the terminal. Wait for a few seconds and you will hear a beep. Once you hear the beep, release the key and you should see a message "default configs used, press return to continue". Press return and the terminal should be reset to factory defaults.

HTH,

Dave