HPE Community
HPE 9000 and HPE e3000 Servers
1753731 Members
4429 Online
108799 Solutions
New Discussion юеВ

MP Reset - does not accept Admin/Admin

 
Bob Viveney_1
Occasional Advisor

тАО10-25-2007 03:15 AM

тАО10-25-2007 03:15 AM

MP Reset - does not accept Admin/Admin

Hello
I have an rp7410 which is connected via RS232 to a vt100 terminal. The MP reset button was pressed and it looks like the operator and LAN settings were set to their defaults. I can log into the MP via Oper/Oper. However I can *not* log in using Admin/Admin. Help?
Thanks
Bob
0 Kudos
3 REPLIES 3
Torsten.
Acclaimed Contributor

тАО10-25-2007 04:02 AM

тАО10-25-2007 04:02 AM

Re: MP Reset - does not accept Admin/Admin

After pressing reset watch the console!

You will see something similar to this:

Resetting GSP.
Press 'p' now to clear all GSP passwords and users......

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Bob Viveney_1
Occasional Advisor

тАО10-25-2007 04:55 AM

тАО10-25-2007 04:55 AM

Re: MP Reset - does not accept Admin/Admin

I finally got the reset and Admin/Admin to work by holding in the MP reset button about 10 seconds. The 'p' prompt did not appear on the vt100 terminal. But the longer reset apparently did reset the Admin password.
0 Kudos
Bob Viveney_1
Occasional Advisor

тАО10-25-2007 04:57 AM

тАО10-25-2007 04:57 AM

Re: MP Reset - does not accept Admin/Admin

Longer hold of the reset button seemed to work.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.