Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Move from 700/96 Terminal to Thin Client

Andrew_M
Occasional Visitor

Move from 700/96 Terminal to Thin Client

Hi, I have an rp3410.

 

It was previously connected to an 700/96 Terminal via cable 24542G, but I would like to be able to connect this to our t5000 series thin client and use that in future.

 

Could anyone advise if it is 'simply' a case of connecting this cable to the thin clients parallel port and then configuring the terminal emulator; or would I need a completely different cable that would connect into its serial port?

 

Many thanks

 

Andrew 

1 REPLY
Torsten.
Acclaimed Contributor

Re: Move from 700/96 Terminal to Thin Client

I think you currently have 25 pin to 9 pin, but you probably need 9 pin to 9 pin.

 

This cable would be nothing special, just null modem.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!