Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Need a 200-240v PDU for rp4440 server

SOLVED
Go to solution

Need a 200-240v PDU for rp4440 server

I have an older HP rack with a PDU HP 5183-1837 PDU which has 200-240vac input (to C20 inlet) and splits the 200 voltage between the 6 outlets (C13 output) for 110v on each 3 sets of outlets and a single outlet to connect to another PDU (C19 outlet) which has 200v out. This works great for the equipment in the rack, a rp5470 and a NetServer 2000r which only require 120vac. I just purchased a rp4440 server that I need to put into the rack and need a PDU for it. The rp4440 requires 200-240vac and came with 2 AC cords that are terminated with C13 and C14 each cord. Does anyone know the Part number of a PDU that I can connect 208V via room power to it and have it output 200v through C13 outlets? Also, I only have one 200v drop in the room so the current PDU must go and I need to replace it with a PDU or a couple of PDU's that I can input 120vac to and get power to my current racked equipment via C13 outlets.

I have only 1 - 208Vac drop in the room but have 6 - 120Vac drops that I can use for the equipment that uses 120vac. The 120Vac is on a single leg so we can not combine to get 208Vac from any combination of them.
I have included a diagram of our current PDU
Thanks in advance for your help.
6 REPLIES
Michael Steele_2
Honored Contributor

Re: Need a 200-240v PDU for rp4440 server

Re: Need a 200-240v PDU for rp4440 server

Thanks Michael, but that PDU in your reply is what I already have in the rack P/N 5183-1837 PDU. I need to replace that one with a PDU that has 120vac input and 120vac out to the serves as stated above. I also need a second PDU that has 200-240vac input and can supply 200-240vac to the 2 Power supplies in the rp4440. Not sure why you send me the links for the same PDU that I am removing?
Andrew Rutter
Honored Contributor
Solution

Re: Need a 200-240v PDU for rp4440 server

Michael Steele_2
Honored Contributor

Re: Need a 200-240v PDU for rp4440 server

HI and Well, you are missing the little dip switch on the module that flips between 120 and 200.
Support Fatherhood - Stop Family Law

Re: Need a 200-240v PDU for rp4440 server

Thank you all for your replys. I was totally mistaken. All of the PDU's are 120-240vac If rated for this. I had incorrectly thought that only the C19 outlets were 240vac and that the C13's outlets were 110vac out. I totally over thought this. Thank you all again. Now for my next post. lol

Re: Need a 200-240v PDU for rp4440 server

Preceived problem has been solved, using a Volt-Ohm-Meter.