- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- HPE 9000 and HPE e3000 Servers
- >
- Power supply will not power up.
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2011 10:20 AM
10-13-2011 10:20 AM
Power supply will not power up.
Greetings, I have an rp7400 (N4000) with three power supplies. Supply in slot 0 failed, so I replaced the unit, but it will not not work. I verified the unit is good, by putting it into an identical box and the green LED comes on as it should when the supply is on. I checked the ac plug inside the rear of the bay and it has power. There are no bent pins etc in the multipin connector on the top of the bay. Does anyone have any ideas? Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2011 10:36 AM
10-13-2011 10:36 AM
Re: Power supply will not power up.
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2011 12:11 PM
10-13-2011 12:11 PM
Re: Power supply will not power up.
Yes master. I wish it was that simple!! I followed the procedure in the service manual, turned off the unit before pluggin in, then truned on the unit. Any other ideas?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-17-2011 12:53 PM
10-17-2011 12:53 PM
Re: Power supply will not power up.
Do you receive any alerts from the GSP after inserting the Power Supply? If no, then the Power Monitor isnt aware that it exists. Perhaps the AC Line filter is faulty?
You may want to confirm that the AC line being used is providing 200-220VAC (110-120VAC will not work).
-Bob
Was this helpful? Like this post by giving me a thumbs up below!