Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Quick question

Waqar Razi
Regular Advisor

Quick question

I have a quick question, is S16K-A and rp8400 are same?

My other question is that is that possible to go on a cell based server like rp8400 without creating npars and vpars on it?
8 REPLIES
Patrick Wallek
Honored Contributor

Re: Quick question

>>S16K-A and rp8400 are same?

I don't think so.

Superdomes -- http://www.hp.com/products1/servers/scalableservers/superdome/comparison.html

rp series including rp8400 -- http://www.hp.com/products1/servers/9000_discontinued.html

>>is that possible to go on a cell based server like rp8400 without creating npars and vpars on it?

You need at least 1 NPAR on a cell based server for it to function. That NPAR can contain ALL hardware in the system. You can then install HP-UX to the NPAR and have a fully functioning system.

You do not need any VPARs. HP-UX can run just fine on the single, all encompassing NPAR.
Waqar Razi
Regular Advisor

Re: Quick question

S16K-A is superdome, right?

Can we do ignite on S16K-A and restore it on rp8400?

Patrick Wallek
Honored Contributor

Re: Quick question

Yes, S16K-A is a 16 processor Superdome.

As to the Ignite tape.... Maybe. The only thing I can advise is to try it. It might work and it might not.
Mel Burslan
Honored Contributor

Re: Quick question

my rp8400 servers respond as S16K-A to command 'model'

SxxK-A is a representation of cell based servers I was told at one time but can not remember who told this to me. Most probably somebody from HP response Center.

So, likelihood of your ignite image working on an rp8400 is quite high I suppose.
________________________________
UNIX because I majored in cryptology...
Jov
Honored Contributor

Re: Quick question

Igiting from a SD to rp8400 will depend on your nPar configuration. If they're identical or very close I can't see why it will not work.


Jov
Duncan Edmonstone
Honored Contributor

Re: Quick question

This WP gives some guidelines on cloning a system to different hardware:

http://docs.hp.com/en/5992-6271/5992-6271.pdf

HTH

Duncan

HTH

Duncan
Torsten.
Acclaimed Contributor

Re: Quick question

The model string of a rp8400 is "9000/800/S16K-A".

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Senthil-kumar
Occasional Advisor

Re: Quick question

yes, S16K-A is the model for rp8400,

The nPar is setup in factory by default. Otherwise you can create it from MP using the CC command.
But you can always modify it after setting up the initial OS onto it.