Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Server will not power up

Dave Chamberlin
Trusted Contributor

Server will not power up

Greetings I have configuring an rp3440 for about a month, no problems. Today it powered itself off and will not power on. I have the redundant power supply. Doing PS in the MP shows normal for both power supplies and all fans. The green LEDs are on on both supplies. The main LED on the front is yellow and flashing. I try a PC (in the MP) and choose on - but it never goes on. Both AC lines to the unit are normal. I looked at chassis logs - nothing about power - but all are BCH related such as BCH   *5   or BCH   2. Any ideas? Thanks

 

 

P.S. This thread has been moevd from Servers > General to HP 9000. - Hp Forum Moderator

 

 

2 REPLIES
Robert_Jewell
Honored Contributor

Re: Server will not power up

Hi Dave,

  Did you try removing the AC lines and then powering on from the front panel?  If that fails you should see a red flashing LED and corresponding events in the MP log.

 

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
Torsten.
Acclaimed Contributor

Re: Server will not power up

The reason could even be a memory or cpu problem, check the logs!


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!