Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Step superdome replace a cell

gigiz
Valued Contributor

Step superdome replace a cell

Hi guy,

i need to replace a cell of a my superdome with 2 Npar . I have noarA and nparB.

I must replace a cell in NparA.

Can i power-off also NparA ?

What is a step?

5 REPLIES
Torsten.
Acclaimed Contributor

Re: Step superdome replace a cell

For replacing the cell it is enough to power off the nPar (not the complex). Make sure the new cell has the same firmware like the other cells, otherwise it will not boot.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
gigiz
Valued Contributor

Re: Step superdome replace a cell

Ok ,

but what is the step by gsp ?

I need of a reboot for reconfig (shutdown -R) ?

Torsten.
Acclaimed Contributor

Re: Step superdome replace a cell

Shutdown the nPar (shutdown -h), then power off (PE command, select nPar).

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
gigiz
Valued Contributor

Re: Step superdome replace a cell

But i can do :

shutdown -hy 0

or BIB mode ?

Torsten.
Acclaimed Contributor

Re: Step superdome replace a cell

# shutdown -h -y 0 will be OK.




Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!