Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

how do i do parmodify for rp8400

kvsheejith
Advisor

how do i do parmodify for rp8400

I have already installed my rp8400 with hpux b11.11. Cell details are as shown bellow

MP:CM> du

The following MP bus devices were found:
+---+----+-----+-------+-------+-----------+
| | | | | | |
| | | Sys | | IO | Bulk Pwr |
|Cab| MP |Bkpln| Cells |Chassis| Supplies |
| # |M S| |0 1 2 3| 0 1 |0 1 2 3 4 5|
+---+----+-----+-------+-------+-----------|
| 0 |* *| * |* * | * * |* * * * * |
+---+----+-----+-------+-------+-----------+

MP:CM> cp

--------------
Cabinet | 0 |
--------+----+
Slot |0123|
--------+----+
Part 0 |.*..|

MP:CM>


i want to add all the cells and I/O s to this partetion. what should be the command i have to type

parmodify -p 0 -a ? :? ?

please guide me .

Thanks.
1 REPLY
sujit kumar singh
Honored Contributor

Re: how do i do parmodify for rp8400

Hi


From the OS can you run the command and give the Outputs of the same.

#parstatus

the basic idea is
#parmodify -p 0 -a :base:y:ri -a :base:y:ri -a :base:y:ri

then perform an RR that is Reboot-for-Reconfig.
but please dp paste an O/p for the command parstatus as run from the server.
#shutdown -Ry 0

regards