Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

question on rp8440 memory upgrade

Trojan36
Frequent Advisor

question on rp8440 memory upgrade

I have a rp8440 with 3 nPars. I need to upgrade memory on one of the nPar. My question is - does the entire complex need to shutdown if I only want upgrade memory on only one of the nPar? Thx in advance.
2 REPLIES
david d_2
Frequent Advisor

Re: question on rp8440 memory upgrade

Nope you only need to shut down the nPar that you will be updating.

Good Luck,
Dave
Ron Irving
Trusted Contributor

Re: question on rp8440 memory upgrade

No. Shutdown the npar, then from the MP type CM, then PE, and choose the cell that belongs to that npar. Power down the cell, remove it, and upgrade the memory. Put the cell back in, and from the MP, power up the cell. You're good to go!!

HTH

ron
Should have been an astronaut.