Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
Showing results for 
Search instead for 
Did you mean: 

rp2470 disk address

Go to solution
Hakki Aydin Ucar
Honored Contributor

rp2470 disk address

Do you have any document or self notes about rp2470 HDD I/O address schema / picture to describe which disk belonging to the which slot ?

I need to change a boot disk on customer rp2470 remotely , as far as I know rp2470 has two disks, one spare , one boot, I ve an ignite backup ,but don t know how to explain which disk is to be changed ?





P.S. This thread has been moevd from Workstations - Itanium-Based, hp9000, Visualize to Servers > HP 9000. - Hp Forum Moderator

Honored Contributor

Re: rp2470 disk address

You posted in the wrong board, so likely a moderator will move your question.


Anyways, here is what I think you are looking for:


Drive A (top disk) - 0/0/1/1.15.0

Drive B (bottom disk) - 0/0/2/1.15.0



Use the 'PA' command from the BCH menu to view what path is setup to be your primary boot disk.




Was this helpful? Like this post by giving me a thumbs up below!