HPE Community
HPE 9000 and HPE e3000 Servers
1752610 Members
4626 Online
108788 Solutions
New Discussion юеВ

Re: rp3410 doesn't boot

 
SOLVED
Go to solution
Andrew Rutter
Honored Contributor

тАО06-22-2010 07:40 AM - last edited on тАО04-21-2022 10:22 PM by

тАО06-22-2010 07:40 AM - last edited on тАО04-21-2022 10:22 PM by

Re: rp3410 doesn't boot

hi,

yes hp made a special tool part number 5069-5441, but you can use just a long allen key 2.5mm, but nedes to be about 5" long to reach the screw.

https://partsurfer.hpe.com/Search.aspx?searchText=5069-5441


a good tool store should have one or Snap-on tools do them over here in the uk.

Andy



0 Kudos
Andrew Rutter
Honored Contributor

тАО06-22-2010 07:41 AM - last edited on тАО04-21-2022 10:23 PM by

тАО06-22-2010 07:41 AM - last edited on тАО04-21-2022 10:23 PM by

Re: rp3410 doesn't boot

hi again,

the manual for the cpu removal is here

[admin: invalid link removed, please visit https://support.hpe.com]
Andy

0 Kudos
Torsten.
Acclaimed Contributor

тАО06-22-2010 08:09 AM

тАО06-22-2010 08:09 AM

Re: rp3410 doesn't boot

The special tools have a torx-tr on one end, the allen wrench on the other end.

You can use other tools too, if they fit.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.