Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rp7410 - can't access BCH

rp7410 - can't access BCH

We have one cell board in slot one (the bottom cell) - one core I/O in slot one (the bottom slot), two 36GB 15k HDs... at one point we had this server loaded with HP-UX. We had to change out CPU's and the RAM configuration.

Now we've lost the ability to get to the BCH to load the OS or even see a POST test...

We go to the >CO and see a prompt for what partition to use, or q for quit. We choose the partition and it hangs.

Should we try and use a terminal emulator to try and upgrade all the firmware on the system? I ran a >CM:SYSREV and the firmware numbers were not all the same...
2 REPLIES
Khairy
Esteemed Contributor

Re: rp7410 - can't access BCH

hi,

from mp, run sl and choose to view errors messages. WOuld be useful if you could post the errors here.

Re: rp7410 - can't access BCH

It turned out to be a couple of bad processors. Thanks.