Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
cancel
Showing results for 
Search instead for 
Did you mean: 

rp7410

Jon Steele
Valued Contributor

rp7410

I am installing a cell board in an RP7410.I can not find out the dip switch settings.I had 750 procs but now I am putting in 875 procs and can not find out what too change the settings to.

Thanks in advance for your help

Jon
5 REPLIES
Jon Steele
Valued Contributor

Re: rp7410

found the solution
Joshua Scott
Honored Contributor

Re: rp7410

Jon,

Where did you find the solution for this? I know I used to have a sheet that outlined this, but I can't seem to find it.

Thanks!
What are the chances...
Jon Steele
Valued Contributor

Re: rp7410

The switch settings for the 875 procs are
10100000 1=off .I hope this helps

Jon
Joshua Scott
Honored Contributor

Re: rp7410

Thanks!
What are the chances...
Jon Steele
Valued Contributor

Re: rp7410

Thanks
Jon