Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
cancel
Showing results for 
Search instead for 
Did you mean: 

rp7410

Jon Steele
Valued Contributor

rp7410

Hi
I was upgrading my firmware for this machine.Everything was going good then it messed up on the cell board firmware.When it was doing the pdhc and the pdc it did not work.Now the firmware level says oo.oo Is there any way to correct this?can I use another cell board and copy the firmware from it to the bad one?Any help is appreciated.

Thanks
Jon
3 REPLIES
freddy_21
Respected Contributor

Re: rp7410

is your step same with the manual upgrade?

try to upgrade again. dont do power cycle. what is the error when you upgrade pdc?

could you provide about cell board configuration ( cp command) and sysrev?

thanks
freddy
Jon Steele
Valued Contributor

Re: rp7410

When it tries to load the pdch and pdc firmware it gives me a timedout error.The machine does not see the cell board anymore.It shows all firmware on the cell board as 0.00 for everything.It was working untill I did the firmware.I put another cell board in same config and the machine boots up fine.I still cannot see the first cell board.Is there a way to copy firmware from the good cell board to the bad one ,or am I out of luck trying to save this cell board?

Jon
Jon Steele
Valued Contributor

Re: rp7410

Thank you
Jon