Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
HP 9000 and HP e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rp8240 doesn't see tape on second MP's SCSI bus

mvpel
Trusted Contributor

rp8240 doesn't see tape on second MP's SCSI bus

Hi all,

I recently installed an rp8420, and it has a disk array connected to the upper MP's SCSI bus which shows up just fine, along with the internal drives.

But a tape drive connected to the lower MP's SCSI bus doesn't appear. There's no sign of it in ioscan, or in STM.

STM shows the upper MP's SCSI bus with the disk array at 0/0/0/3, and there's a second set of SCSI busses on cell 1 at 1/0/0, including 1/0/0/3 - is this the lower MP's SCSI bus? Maybe there's just a problem with the tape drive and/or the cabling to it?

The box is running HP-UX 11.11, and all the firmware was upgraded to the latest revisions.

Thanks for any information you can offer.
1 REPLY
Torsten.
Acclaimed Contributor

Re: rp8240 doesn't see tape on second MP's SCSI bus

Path 1/0/0/3/1 is correct. Check cable, terminator and device now.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!