GSP network settings

[Christopher M]

I am trying to access a gsp on an L2000 server 5191A, A5522A (440MHz)via the LAN connection (local serial works fine). I have set the IP, name, gateway (LC) and enabled the LAN (LC) but when the network cable is plugged in there is no activity light flickering, only the single light to indicate the cable is plugged in. The network cable functions with a laptop plugged in and configured with the same parameters as the GSP. Is there some duplex or other setting I need to tak into account that the PC is able to auto negotiate, but the GSP is not? Thanks - Christopher

[Patrick Wallek · Accepted solution]

I think the GSP on the L2000 machines is a 10 Mbit half-duplex port. If you can, set your switch to 10HD or Auto Neg and see what happens.

[Christopher M]

Thanks Patrick! I have had the network guys change the port to 10/half and it works fine now. (it was set to 100/full)