HP 9000
cancel
Showing results for 
Search instead for 
Did you mean: 

Need a 200-240v PDU for rp4440 server

SOLVED
Go to solution

Need a 200-240v PDU for rp4440 server

I have an older HP rack with a PDU HP 5183-1837 PDU which has 200-240vac input (to C20 inlet) and splits the 200 voltage between the 6 outlets (C13 output) for 110v on each 3 sets of outlets and a single outlet to connect to another PDU (C19 outlet) which has 200v out. This works great for the equipment in the rack, a rp5470 and a NetServer 2000r which only require 120vac. I just purchased a rp4440 server that I need to put into the rack and need a PDU for it. The rp4440 requires 200-240vac and came with 2 AC cords that are terminated with C13 and C14 each cord. Does anyone know the Part number of a PDU that I can connect 208V via room power to it and have it output 200v through C13 outlets? Also, I only have one 200v drop in the room so the current PDU must go and I need to replace it with a PDU or a couple of PDU's that I can input 120vac to and get power to my current racked equipment via C13 outlets.

I have only 1 - 208Vac drop in the room but have 6 - 120Vac drops that I can use for the equipment that uses 120vac. The 120Vac is on a single leg so we can not combine to get 208Vac from any combination of them.
I have included a diagram of our current PDU
Thanks in advance for your help.
6 REPLIES
Michael Steele_2
Honored Contributor

Re: Need a 200-240v PDU for rp4440 server

Re: Need a 200-240v PDU for rp4440 server

Thanks Michael, but that PDU in your reply is what I already have in the rack P/N 5183-1837 PDU. I need to replace that one with a PDU that has 120vac input and 120vac out to the serves as stated above. I also need a second PDU that has 200-240vac input and can supply 200-240vac to the 2 Power supplies in the rp4440. Not sure why you send me the links for the same PDU that I am removing?
Andrew Rutter
Honored Contributor
Solution

Re: Need a 200-240v PDU for rp4440 server

Michael Steele_2
Honored Contributor

Re: Need a 200-240v PDU for rp4440 server

HI and Well, you are missing the little dip switch on the module that flips between 120 and 200.
Support Fatherhood - Stop Family Law

Re: Need a 200-240v PDU for rp4440 server

Thank you all for your replys. I was totally mistaken. All of the PDU's are 120-240vac If rated for this. I had incorrectly thought that only the C19 outlets were 240vac and that the C13's outlets were 110vac out. I totally over thought this. Thank you all again. Now for my next post. lol

Re: Need a 200-240v PDU for rp4440 server

Preceived problem has been solved, using a Volt-Ohm-Meter.