HPE Community
HPE 9000 and HPE e3000 Servers
1752276 Members
4721 Online
108786 Solutions
New Discussion юеВ

Re: add memory in rp8420

 
SOLVED
Go to solution
soporte_plataformas
New Member

тАО05-27-2009 01:49 AM

тАО05-27-2009 01:49 AM

add memory in rp8420

we need to add dimms to rp8420, but we have a doubt, we see the following requirement "Memory must be installed in quads (4 DIMMs of equal density)" in http://h18000.www1.hp.com/products/quickspecs/11894_na/11894_na.HTML, however, in A6912-96023.pdf manual say "DIMMs must be loaded in sets of two at specified locations on the cell board."

What is correct configuration?

Thank you.

0 Kudos
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО05-27-2009 02:24 AM

тАО05-27-2009 02:24 AM

Solution

Re: add memory in rp8420

AFAIK pairs ("echelons") are enough, but for performance reasons you should always use "pairs of echelons" = quads. Note: The page you posted says "memory is always **sold** as quads", so use quads to get performance.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
soporte_plataformas
New Member

тАО05-27-2009 02:37 AM

тАО05-27-2009 02:37 AM

Re: add memory in rp8420

Thank you for your prompt reply.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.