Simpler Navigation coming for Servers and Operating Systems
Coming soon: a much simpler Servers and Operating Systems section of the Community. We will combine many of the older boards, and you won't have to click through so many levels to get at the information you need. If you are looking for an older board and do not find it, check the consolidated boards, as the posts are still there.
cancel
Showing results for 
Search instead for 
Did you mean: 

console log

navin
Super Advisor

console log

how to see console log in GSP
thanks
Learning ...
5 REPLIES
Dennis Handly
Acclaimed Contributor

Re: console log

Control-B to get into the GSP. And I think SL will show logs. You can use HE to get help on the commands.
Taifur
Respected Contributor

Re: console log

Hi Navin,

From gsp

use HE for command

you can check it by SL for all log

If helps, pls assign point.

Rgds//
Taifur
Jozef_Novak
Respected Contributor

Re: console log

Hello,

log in to the GSP. From the main menu, select SL (Show Event Logs). Now select either Foward Progress Log or Event Log. Next, setup filter (you can view either all logs or filter them out based on alert level). After the logs are displayed, you can browse them using + or - key.

HTH,
J.
Senthil-kumar
Occasional Advisor

Re: console log

From GSP prompt, type CL for Console logs
Torsten.
Acclaimed Contributor

Re: console log

(C)onsole (L)ogs = cl

GSP> he li


HE LI


==== GSP Help ============================================(Operator)========
AC : Alert display Configuration PS : Power management module Status
CA : Configure asynch/serial ports RS : Reset System through RST signal
CL : Console Log- view console history SDM : Set Display Mode (hex or text)
CO : COnsole- return to console mode SE : SEssion- log into the system
CSP : Connect to remote Service Proc. SL : Show Logs (chassis code buffer)
DI : DIsconnect remote or LAN console SS : System Status of proc. modules
EL : Enable/disable LAN access TC : Reset via Transfer of Control
ER : Enable/disable Remote/modem TE : TEll- send a msg. to other users
HE : Display HElp for menu or command VFP : Virtual Front Panel display
LS : LAN Status WHO : Display connected GSP users
MR : Modem Reset XD : Diagnostics and/or Reset of GSP
MS : Modem Status XU : Upgrade the GSP Firmware
PC : Remote Power Control


GSP> cl

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!