HPE Community
HPE 9000 and HPE e3000 Servers
1751894 Members
5084 Online
108783 Solutions
New Discussion юеВ

Re: mp login

 
newunix
Frequent Advisor

тАО05-27-2010 08:12 AM

тАО05-27-2010 08:12 AM

mp login

server model rp3440

i need to take console login, but we dont have mp login ip and no console cable available.

but we have cross over cable. is it possiable to take mp login using cross wire cable .

if so can i have steps and where i have to connect cross cable in server to windows pc
0 Kudos
3 REPLIES 3
stephen peng
Valued Contributor

тАО05-27-2010 08:22 AM

тАО05-27-2010 08:22 AM

Re: mp login

As I recall, the default MP lan setting should be: IP/192.168.1.1, netmask/255.255.255.0, so just modify you pc lan setting to 192.168.1.2/24 and then connect the cross over cable to MP LAN and telnet 192.168.1.1, you should be able to login MP.
0 Kudos
Torsten.
Acclaimed Contributor

тАО05-27-2010 09:26 PM

тАО05-27-2010 09:26 PM

Re: mp login

Depending on firmware version the default is DHCP.

So if you don't know the IP and you don't have a serial cable, try system management homepage from OS if it detects the MP.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
SoorajCleris
Honored Contributor

тАО06-04-2010 09:32 AM

тАО06-04-2010 09:32 AM

Re: mp login

Hi, If nothing works,

Reset the MP, set IP using ARP and MAC

Regards,
Sooraj
"UNIX is basically a simple operating system, but you have to be a genius to understand the simplicity" - Dennis Ritchie
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.