HPE Community
HPE 9000 and HPE e3000 Servers
1752802 Members
5210 Online
108789 Solutions
New Discussion юеВ

question on rp8440 memory upgrade

 
Trojan36
Frequent Advisor

тАО10-16-2008 01:46 PM

тАО10-16-2008 01:46 PM

question on rp8440 memory upgrade

I have a rp8440 with 3 nPars. I need to upgrade memory on one of the nPar. My question is - does the entire complex need to shutdown if I only want upgrade memory on only one of the nPar? Thx in advance.
0 Kudos
2 REPLIES 2
david d_2
Frequent Advisor

тАО10-16-2008 05:28 PM

тАО10-16-2008 05:28 PM

Re: question on rp8440 memory upgrade

Nope you only need to shut down the nPar that you will be updating.

Good Luck,
Dave
0 Kudos
Ron Irving
Trusted Contributor

тАО10-17-2008 03:51 AM

тАО10-17-2008 03:51 AM

Re: question on rp8440 memory upgrade

No. Shutdown the npar, then from the MP type CM, then PE, and choose the cell that belongs to that npar. Power down the cell, remove it, and upgrade the memory. Put the cell back in, and from the MP, power up the cell. You're good to go!!

HTH

ron
Should have been an astronaut.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.