HP 9000
cancel
Showing results for 
Search instead for 
Did you mean: 

rp7410 Cell board firmware

bagek
Frequent Advisor

rp7410 Cell board firmware

I am trying to add an additional cell board to my rp7410. Both boards have 2 gb memory and 2 875MHz cpu. When I boot with both cells the system fails to boot with an error reporting a mismatch between the firmware of the cell boards. Both cells will boot independently. How do I update the cell board frimware? thanks. 

4 REPLIES
Torsten.
Acclaimed Contributor

Re: rp7410 Cell board firmware

Locate the firmware budle on hp.com and read the release notes carefully!
Doing a wrong step (not following the instructions) may destroy your server!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: rp7410 Cell board firmware

Here  it is:

http://h20565.www2.hp.com/portal/site/hpsc/template.PAGE/public/psi/swdDetails/?sp4ts.oid=86782&spf_p.tpst=psiSwdMain&spf_p.prp_psiSwdMain=wsrp-navigationalState%3Dlang%253Den%257Ccc%253DUS%257CprodSeriesId%253D2512354%257CswItem%253DPF-CKEYMAT0605%257CprodNameId%253D86782%257CswEnvOID%253D7%257CswLang%253D13%257Cmode%253D4%257Cidx%253D0%257Caction%253DdriverDocument&javax.portlet.begCacheTok=com....


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
bagek
Frequent Advisor

Re: rp7410 Cell board firmware

i upgraded both cell boards and MP boards. sysrev confirms they are the same and the latest. however now when i power on the selftest see's only cell 1. both cells test fine in slot 1.

Robert_Jewell
Honored Contributor

Re: rp7410 Cell board firmware

Perahps you have this figured out by now....

 

>  selftest see's only cell 1.

 

So you mean in the VFP view?   If so then only one cell may be configured into the partition.

 

Run MP:CM> CP to view what cells are configured.  Does the partition boot?  Does the OS boot? Use parmodify from the OS to add a cell.

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!