L3000 시리얼 볼려고 stm 을 실행했는데 자꾸 에러가 나네요..
고수님들 이 문제좀 해결해 주세요
에러 내용은 아래와 같습니다.
An unexpected error was encountered while attempting to retrieve the
host info for hostname (keims4.kopec.co.kr).
This could be due to any of the following conditions:
1) The support tool daemon "diagmond" may not be running on that system.
Use the STM Startup command (in the administration menu under the
file menu.)
2) The support tool daemon "diagmond" on that system may be configured
to only allow local connections. Check the value of the configuration
parameter LOCAL_ONLY_ENABLE in the /var/stm/config/sys/diagmond.cfg
file or for the existence of the /var/stm/config/sys/local_only file
on that system.
3) The diagnostic system on this system may be configured
to only allow local connections. Check for the existence of the
/var/stm/config/sys/local_only file on this system.
4) The IP address for the system may be invalid or may not be associated
with a valid host. Use a valid IP address.
5) Networking may be incorrectly configured on one of the systems involved.
Verify networking by comparing 'nslookup `hostname`' with the output
of ifconfig of the LANs identified by lanscan.
More details may be available in the System Activity Log and in the
syslog on that system.
It may be necessary to access these using the Local Unit Under Test (UUT) logs
(in the
administration menu under the file menu.)
Please Refer to the UI Activity Log for more details.
