HP-UX

cstm 실행이 않됩니다.

 
허남경
비정기 조언자

cstm 실행이 않됩니다.

cstm 실행시 아래와 같은 error 가 발생하며 실행이 되지 않습니다.

diagmond restart도 해봤구요..

원인을 모르겠습니다..



답변 부탁 드려요 ^^



감사합니다.



Running Command File (/usr/sbin/stm/ui/config/.stmrc).



Waiting to obtain host information from the local host TSWAS2.

The diagnostic daemon "diagmond" may have been started recently and is busy

building the device map.



If this message persists for a long time, it is possible that either the

diagnostic daemon is not running, or that networking is improperly configured.

The networking configuration can be verified by comparing 'nslookup `hostname`'

with the output of ifconfig of the LANs identified by lanscan.



If you cancel this message, the User Interface (UI) will not automatically

connect to a Unit Under Test (UUT). It will be necessary to use the Select

Current System command in the System menu to attach the UI to a UUT.





-- Error --

An unexpected error was encountered while attempting to retrieve the

host info for hostname (TSWAS2).

This could be due to any of the following conditions:



1) The support tool daemon "diagmond" may not be running on that system.

Use the STM Startup command (in the administration menu under the

file menu.)



2) The remote system is running an obsolete version of STM. To

communicate successfully, update the diagnostics on the remote

system to STM version B.40.00 or later.



3) The support tool daemon "diagmond" on that system may be configured

to only allow local connections. Check the value of the configuration

parameter LOCAL_ONLY_ENABLE in the /var/stm/config/sys/diagmond.cfg

file or for the existence of the /var/stm/config/sys/local_only file

on that system.



4) The diagnostic system on this system may be configured

to only allow local connections. Check for the existence of the

/var/stm/config/sys/local_only file on this system.



5) The IP address for the system may be invalid or may not be associated

with a valid host. Use a valid IP address.



6) Networking may be incorrectly configured on one of the systems involved.

Verify networking by comparing 'nslookup `hostname`' with the output

of ifconfig of the LANs identified by lanscan.



7) For a successful connection, UI and UUT must be compatible.



More details may be available in the System Activity Log and in the

syslog on that system.

It may be necessary to access these using the Local Unit Under Test (UUT) logs

(in the

administration menu under the file menu.)

Please Refer to the UI Activity Log for more details.



-- Error --

An unexpected error has been encountered.

Please Refer to the UI Activity Log for more details.



-- Information --

Aborting all open command files.
1 응답 1
고재진
중학생

cstm 실행이 않됩니다.

안녕하세요.



우선 시스템 hostname이 /etc/hosts 파일과 일치하는지 확인하세요.



그리고 cstm 데몬을 restart해보세요.

(/sbin/init.d/diagnostic stop,start)



그래도 안되시면 최신 stm을 설치하시면 됩니다.



그럼.