HP e3000
cancel
Showing results for 
Search instead for 
Did you mean: 

Console messages ( recall , reply )

Console messages ( recall , reply )

We have just put in an N4000 and operator intervention messages that need replied to are not being displayed on the console. Any ideas
5 REPLIES
Ginette Vincent
Occasional Advisor

Re: Console messages ( recall , reply )

Setmsg may be disabled. At the prompt type "setmsg on".
paul courry
Honored Contributor

Re: Console messages ( recall , reply )

Also, type CONSOLE and see where your logical console is.

Re: Console messages ( recall , reply )

Sorry folks, setmsg is on and console is at 20.
I am thinking it is some logging setting in NMMGR but am not familiar enough with subsystem class logging, yet....

Re: Console messages ( recall , reply )

Ok...if your run EasyTime, console messages by default are turned off to the console. They must be enabled to go to EasyTime and console. Sounds kind of hokey to me, but hey, that's just my opinion...thx everybody for your help...
paul courry
Honored Contributor

Re: Console messages ( recall , reply )

BTW have you checked to see that REMOTE MODE has an asterisk beside it and that you can type in commands from the console?

As an aside, here is our logging setup, but you will find it in SYSGEN, not NMMGR

log>sh

configurable item max min current
----------------- ------- ------- -------
# of user logging processes 128 2 128
# users per logging process 1140 1 1024

system log events event # status
----------------- ------- ------
System Logging 100 ON
System Up 101 ON
Job Initiation 102 OFF
Job Termination 103 OFF
Process Termination 104 OFF
NM File Close 105 OFF
System Shutdown 106 ON
Power Failure 107 ON
I/O Error 111 ON
Physical Mount/Dismount 112 OFF
Logical Mount/Dismount 113 OFF
Tape Label 114 OFF
Console Log 115 ON
Program File Event 116 ON
Native Mode Spooling 120 OFF
File Quarantine Event 121 OFF
Chdir 127 OFF
Process Adoption 128 OFF
File Owner Change 129 OFF
Architected InterFace 130 OFF
Additional Processor Launch 131 OFF
Password Change 134 OFF
System Logging Configuration 135 OFF
Restore 136 OFF
Printer Access Failure 137 OFF
ACD Change 138 OFF
Stream Initiation 139 OFF
User Logging 140 OFF
Process Creation 141 OFF
Security Configuration Change 142 OFF
Chgroup 143 OFF
File Open 144 OFF
CI Command Logging 145 OFF
Maintenance Request 146 ON
UPS Monitor Event Logging 148 ON
Diagnostic Information 150 ON
High Priority Machine Check 151 ON
Low Priority Machine Check 152 ON
Directory Open/Close Logging 155 OFF
CM File Close 160 OFF
log>