Community
HPE 3PAR StoreServ Storage

11iV3 and 3PAR array

 
placitasmd
Frequent Advisor

‎07-21-2009 07:41 AM - last edited on ‎01-17-2012 01:38 AM by

‎07-21-2009 07:41 AM - last edited on ‎01-17-2012 01:38 AM by

11iV3 and 3PAR array

Looking for any docs around best practices with 11iV3 and 3PAR arrays. Having some issues when trying to grow VGs (adding additioanl devices) and expand LVs. Commands hang and need to reboot the system to clear condition. Not having the same issue when using an EMC SYMM array.

 

 

P.S. This thread from Storage --> Disk --> Disk Array to Storage --> Storage Area Network (SAN) --> Storage Area Network (Enterprise)

Mark E Duhamel
0 Kudos
Reply
2 REPLIES 2
Sebastian.Koehler
Honored Contributor

‎01-17-2012 11:57 AM

‎01-17-2012 11:57 AM

Re: 11iV3 and 3PAR array

Check the 3PAR HP-UX Implementation Guide...

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02887524/c02887524.pdf

Regards,
Sebastian
0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎01-17-2012 10:16 PM

‎01-17-2012 10:16 PM

Re: 11iV3 and 3PAR array

See this thread:

 

http://h30499.www3.hp.com/t5/Storage-Area-Networks-SAN/3PAR-HPUX-and-DLE/m-p/5423215#M61301


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.