3PAR- 7200c disk issue

[Dsinghp2002]

Dear Srinivas,

Still issue is same, i am unable to dismiss pdid 17 bcoz 1 chunklet is present there. PFB,

And same chunklet is missing PDid 18. PFB,

So need procedure to moved or delete present chunklet in pdid 17 afterward i can dismiss pdid 17. 

[sbhat09]

Hello @Dsinghp2002,

Please run this command to recover the chunklet.

checkld -recover 17:1106

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE.

[sbhat09]

If the chunklet recovery fails, try to move the chunklet from PD17 to PD18 with the command:

movech 17:1106-18:1106

If you still face issue, you can try to force run the command 'movech -f 17:1106-18:1106'
The destination position (1106) of the chunklet may be different as well except any of the occupied positions.

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE.

[Dsinghp2002]

Dear Srinivas,

Given procedure not worked. PFB,

[sbhat09]

Hello @Dsinghp2002,

Make sure the LD 'log0.0' is not not mapped to any VVs
You can check that with the command 'showldmap log0.0'
Then run the command 'removeld media-fail.17.1106'

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE.

[sbhat09]

Hello @Dsinghp2002,

Do you have any updates for me?

Hope you found it useful. Let me know if you need further assistance.

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE.

[Dsinghp2002]

Srinivas,

Still it is not resolved. PFB,

[sbhat09]

Hello @Dsinghp2002,

All out attempts to recover chunklet and remove chunklet didn't work.

The LD is not mapped to any volumes. So you can remove the LD.

Please run the command 'removeld log0.0'

To force remove, use the command 'removeld -f log0.0' 

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE.

[Dsinghp2002]

not worked. PFB

[sbhat09]

I will check further about this and get back to you.