- Community Home
- >
- Storage
- >
- Midrange and Enterprise Storage
- >
- HPE 3PAR StoreServ Storage
- >
- 3Par F-class, After power outage Node2 is in Joini...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2016 10:46 AM
05-20-2016 10:46 AM
3Par F-class, After power outage Node2 is in Joining Cluster mode
Hi,
We have 3par F400 system configured with two nodes (Node2 & Node3), four shelves, and 8 x 300 GB FC disks.
After power outage, system came up, but Node2 is in “Joining Cluster” mode, helthcheck shows “Could not check task: System power fail recovery in progress - try this command later.” Apparently the problem is not in nodes, I did swap the nodes and yet node2 is having the same issue. Node3 is up and running fine. Node status LED: Node3 – 1blink/sec, node active in cluster, Node2 – solid green, Joining cluster.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2016 04:33 AM
06-29-2016 04:33 AM
Re: 3Par F-class, After power outage Node2 is in Joining Cluster mode
Hello 2know3par,
Pfail / powerfail process recovery is done to restore services to the Inserv Node and to flush the data from teh data to the disks.
The issue is predominantly seen when the data from the pfail partition is able to migrate to the destination. power recovery is common after accidental powerloss. The biffer issue here is to see all your VVs and LDs are started and normal.
run a showvv or showvv -f command to check all the VV states.
Also run showld command to check the same for the LD.
Run showsysmgr to find the state of pfail.
When you siad, the node was swapped out, do you mean that the node was replaced with a new one or was it re-seated ?
~Nirupak
Nirupak
Technical Solutions Specialist- Advanced Solution Center