HPE 3PAR StoreServ Storage
1748283 Members
3943 Online
108761 Solutions
New Discussion

Re: Correct registry 3PAR into InfoSight

 
Danmind
Occasional Advisor

Correct registry 3PAR into InfoSight

I successfully registered 3PAR with HPE InfoSight via SSMC (System -> Action -> Edit - add token to Comments and General Settings -> HPE InfoSight). Do I also need to register the token in 3PAR Service Console -> System -> Action -> Edit System - Installation Site - Register with HPE InfoSight? Our version VSP 5.0.4.0, OS 3.3.1 MU2.

1 REPLY 1
Sheldon Smith
HPE Pro

Re: Correct registry 3PAR into InfoSight

When done on the StoreServ, the token is collected in the CONFIG report and sent in. This is typically done three times a day. When done on the Service Processor, the SP sends it immediately.
Either will work; both send it to our STaTS repository, where it then goes to InfoSight.


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo